Connecting Wires To Terminals - Kenwood eXcelon KDC-X792 Instruction Manual

Connecting Wires to Terminals

To USB device
USB connector (1m)
⁄
Do not remove the
cap when you do not
use the USB cable. The
connector will cause
the unit to malfunction
if it gets in touch with
any metallic part of the
vehicle.
Wiring harness
(Accessory1)
Power control wire (Blue/White)
Motor antenna control wire (Blue)
TEL mute wire (Brown)
Dimmer control wire (Orange / White)
Ignition wire (Red)
Battery wire (Yellow)
Ground wire (Black) · (To car chassis)
34
|
KDC-X792/KDC-X692/KDC-MP738U/KDC-MP638U
Steering remote control
(Light Blue/Yellow)
REMO.CONT
To use the steering
wheel remote control
feature, you need to
an exclusive remote
adapter (not supplied)
matches your car is
required.
Fuse (10A)
To Kenwood disc changer/ External optional accessory
⁄
To connect these leads, refer to the relevant
instruction manuals.
White
To front left speaker
White/Black
Gray
Gray/Black To front right speaker
Green
To rear left speaker
Green/Black
Purple
Purple/Black To rear right speaker
If no connections are made, do not let the wire come out from the tab.
When using the optional power amplifier, connect to its power control
terminal.
P.CONT
Depending on what antenna you are using, connect either to the control
terminal of the motor antenna, or to the power terminal for the booster
ANT.
CONT
amplifier of the film-type antenna.
Connect to the terminal that is grounded when either the telephone
rings or during conversation.
MUTE
⁄
To connect the Kenwood navigation system, consult your
navigation manual.
To car light control switch
ILLUMI
Car fuse
box
ACC
Rear output
L R
Front output
Sub Woofer output
FM/AM antenna input
AUX input (Stereo)
Use the mini-plug which is stereo type and does
not have any resistance.
Ignition key
switch
Car fuse box
(Main fuse)
– +
Battery