Subwoofer Output; Sound Field Control - Kenwood eXcelon KDC-X789 Instruction Manual

General features

Subwoofer Output

Turning the Subwoofer output ON or OFF.
Hold down on [AM] of the Control knob for at
least 1 second.
Each time the button is pressed, Subwoofer
output switches ON and OFF.
When it's ON, "SW ON" is displayed.
• You can control this item when <Switching preout>
(page 43) is set to "SWPRE Sub-W". (KDC-MP728/
MP628 only)
• You can control this item when Speaker Select
Subwoofer of <Sound Management system> (page
15) is set to any item other than "None". (KDC-X889/
MP828 only)
• You can control this item when "2 ZONE" of <Audio
Setup> (page 12/13) is set to "OFF".
Function of the KDC-X889/KDC-MP828

Sound Field Control

1
Select the source for adjustment
Press the [SRC] button.
2
Select the key function section
Press the [NEXT] button.
Repeatedly press the button until "S.F.C" is
displayed above the [1] button.
Refer to <Notes on Multi-function Key System>
(page 9).
3
Enter Sound Field Control mode
Press the [1] ("S.F.C") button.
• When "2 ZONE" of <Audio Setup> (page 13) is ON,
you cannot select "S.F.C".
14
|
English
4
Select the Sound Field Control item for
adjustment
Press the [1] — [3] and [5] button.
Each time the [1] — [3] and [5] button is pressed,
the adjustable audio items are switched among
ranges of all stage section's tables on the
following pages.
Multi-function key operation
[1] "XOver" [1] "Front"*
[1] "Rear"*
[1] "SW"*
[2] "DTA" [2] "Front"
[2] "Rear"
[2] "SW"
[3] "POSI"
[5] "Preset" [1] "CALL"
[2] "MEM"
• * The following adjustment items can be selected by
[FM] or [AM] knob for "XOver".
[1] "XOver"
[FM] or [AM] Knob
"Front"
"Rear"
"SW"
• "Preset": You can store an adjusted audio control
value by selecting "MEM". Refer to <Memory
mode> (page 18). Also, you can recall it by
selecting "CALL". Refer to <Memory Recall
mode> (page 18).
• "SW" can be adjusted when <Subwoofer Output>
(page 14) is set to "SW ON"
• Xover (Crossover Network Setup)
You can manually set a crossover frequency of
speakers.
• DTA (Digital Time Alignment)
Manually set the sound output timing of each
channel.
Sound Field control item
High Pass Filter Front
High Pass Filter Rear
Low Pass Filter Subwoofer
DTA Front
DTA Rear
DTA Subwoofer
Position Setting
Call mode
Memory mode
Front High Pass Filter Center
Front High Pass Filter Slope
Rear High Pass Filter Center
Rear High Pass Filter Slope
Subwoofer Low Pass Filter Center
Subwoofer Low Pass Filter Slope
Subwoofer Low Pass Filter Phase