Category And Channel Search; Direct Access Tuning; Selecting The Preset Band; Channel Preset Memory - Kenwood eXcelon KDC-X789 Instruction Manual

SIRIUS tuner control features

Category and Channel Search

Selecting the channel and category you want to
receive.
1
Enter Category and Channel Search mode
Press the Control knob.
2
Select the Category
Push the Control knob to [FM] or [AM].
• It is the item when the category of Middle text display
part is selected.
3
Select the Channel
Push the Control knob to [4] or [¢].
• Channel search cannot be done until the category
information is acquired.
Cancelling Category and Channel Search
mode
Press the Control knob.
Function of remote

Direct Access Tuning

Entering the channel and tuning.
1
Enter Direct Access Tuning mode
Press the [DIRECT] button on the remote.
2
Enter the channel
Press the number buttons.
3
Do Channel Search
Push the Control knob to [4] or [¢].
Canceling Direct Access Tuning
Press the [DIRECT] button on the remote.
• If you make no button operation for 10 seconds, the
Direct Access Tuning mode is automatically canceled.
• You can set up until Channel number 223.
• If there is no signal in the input Channel, "NO
CHANNEL" appears. (KTC-SR901: optional accessory)
• You cannot search for a channel number which is not
broadcasting.
(KTC-SR902/KTC-SR903: optional accessory)
• If you cannot receive any signal in the input Channel
due to a bad condition on radio wave or another
problem, "Acquiring Signal" appears.
38
|
English

Selecting the Preset Band

Push the Control knob to [FM].
Each time the knob is pushed, the preset band
switches between the SR1, SR2, SR3 and SR4.

Channel Preset Memory

Putting the channel in the memory.
1
Select the preset band
Push the Control knob to [FM].
2
Select the channel to put in the memory
Push the Control knob to [4] or [¢].
3
Select the key function section
Press the [NEXT] button.
Repeatedly press the button until "[1]" — "[6]" are
displayed above the [1] — [6] buttons.
Refer to <Notes on Multi-function Key System>
(page 9).
4
Put the channel in the memory
Press the desired [1] — [6] button for at least
2 seconds.
The preset number display blinks 1 time.
On each band, 1 channel can be put in the
memory on each [1] — [6] button.
• Only the channel number is stored. Category
information is not stored.

Preset Tuning

Calling up the channels in the memory.
1
Select the preset band
Push the Control knob to [FM].
2
Select the key function section
Press the [NEXT] button.
Repeatedly press the button until "[1]" — "[6]" are
displayed above the [1] — [6] buttons.
3
Call up the channel
Press the desired [1] — [6] button.