Speaker Setting; Subwoofer Output; Tel Mute - Kenwood KDC-X8006U Instruction Manual

Speaker Setting

Fine-tuning so that the System Q value is optimal
when setting the speaker type.
1
Enter Standby
Press the [SRC] button.
Select the "STANDBY" display.
Refer to <Selecting the Source> (page 6).
2
Enter Speaker Setting mode
Press the [VOL] knob.
"SP SEL" is displayed.
3
Select the Speaker type
Turn the [VOL] knob.
Each time you turn the knob, the setting alternates
between the settings shown in the table below.
Speaker type
OFF
For 5 & 4 in. speaker
For 6 & 6x9 in. speaker
For the OEM speaker
4
Exit Speaker Setting mode
Press the [VOL] knob.

Subwoofer Output

Turning the Subwoofer output ON or OFF.
Push the Control knob toward down for at least
2 seconds.
Each time you push the knob, Subwoofer output
switches ON and OFF.
When it is ON, "SUB WOOFER ON" is displayed.
Display
"OFF"
"5/4inch"
"6x9/6inch"
"O.E.M."

TEL Mute

The audio system automatically mutes when a call
comes in.
When a call comes in
"CALL" is displayed.
The audio system pauses.
Listening to the audio during a call
Press the [SRC] button.
The "CALL" display disappears and the audio system
comes back ON.
When the call ends
Hang up the phone.
The "CALL" display disappears and the audio system
comes back ON.
⁄
• To use the TEL Mute feature, you need to hook up
the MUTE wire to your telephone using a commercial
telephone accessory. Refer to <Connecting Wires to
Terminals> (page 34).
|
English
9