Horizontal Surface Mounting - HP J9661A Installation And Getting Started Manual

C a u t i o n
3. For under-table mounting, a third 20-mm M4 tap screw can be placed
against one side of the switch to secure it in place.

Horizontal Surface Mounting

Place the switch on a table or other horizontal surface. The switch comes with
rubber feet in the accessory kit that can be used to help keep the switch from
sliding on the surface.
Attach the rubber feet to the four corners on the bottom of the switch within
the embossed angled lines. Use a sturdy surface in an uncluttered area. You
may want to secure the networking cables and switch power cord to the table
leg or other part of the surface structure to help prevent tripping over the
cords.
Ensure the air flow is not restricted around the sides and back of the switch.
Figure 2-8. Horizontal surface mounting
Installing the Switch
Installation Procedures
2-13