Horizontal Surface Mounting - HP 8200 zl Installation And Getting Started Manual

Installing the HP 8200 zl Switches
Installation Procedures
4.
install and tighten the
other 12-24 screws
Figure 2-4. Screws in Bracket Being Installed

Horizontal Surface Mounting

Place the switch on a table or other horizontal surface. Use a sturdy surface
in an uncluttered area. You may want to secure the networking cables and
switch power cord to the table legs or other part of the surface structure to
help prevent people from tripping over the cords.
N o t e
Ensure the air flow is not restricted around the sides and back of the switch.
2-10
Install the other screw into the upper hole in each bracket. Tighten these
screws.