Power Amp Section - Samson XM410 Owner's Manual

Controls and Functions
FRONT PANEL CONTROLS

POWER AMP SECTION

The XM410's power amplifier section can
be configured to operate several ways
depending on whether you need MAIN
plus MONITOR amplifiers to power your
speakers, or if you just need more power
for the MAIN speakers. The section below
describes the XM410 power amp modes.
10
Mode - Power amp Mode switch
The MODE switch is used to select one of
three different operating modes, MAIN-
MONITOR, MAIN-MAIN and MAIN-BRIDGE.
The following is a description of each of
the POWER operating modes:
CAUTION!
Only change the power amp mode switch when the XM410's power is
MAIN-MONITOR
With this setting, the MAIN and MONITOR sections can be used independently. The MAIN bus signal will
be sent from the POWER AMP 2 jack, and the MONITOR bus signal will be sent from the POWER AMP 1
jack.
MAIN-MAIN
With this setting, the two power amp channels can be used independently. The MAIN bus signal will be
output from the POWER AMP 1 jack (Rear Panel), and also, from the POWER AMP 2 jack (Rear Panel 1)
MAIN-BRIDGE
With this setting, the two power amp channels (A and B) will be connected in bridge mode. Only the
MAIN bus signal will be output from the BRIDGE jack.
6
SWITCHED OFF!
.