Cisco 7120 Series User Manual page 31

Chapter 1 Overview
•
•
•
Figure 1-32 Port Adapter Slot Numbering—Cisco 7140 Series
5
I
EN
Interface Information in the Software
You can identify interfaces by using software commands. To display information about all interfaces,
use the show interfaces command. To display information about a specific interface, use the show
interfaces command with the interface type, slot number, and port number in the format show interfaces
type slot/port.
The following example shows how the show interfaces command, used without arguments, displays
status information (including the slot and port number) for each interface in a Cisco 7100 series VPN
router. In the following example, most of the status information for each interface is omitted:
Router# show interfaces
FastEthernet0/0 is up, line protocol is up
Hardware is DEC21140A, address is 0050.73ff.6300 (bia 0050.73ff.6300)
Internet address is 10.0.0.0/1
MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec,
FastEthernet0/1 is administratively down, line protocol is down
Hardware is DEC21140A, address is 0050.73ff.6301 (bia 0050.73ff.6301)
Internet address is 10.0.0.0/2
MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,
Serial1/0 is administratively down, line protocol is down
Hardware is M2T-T3 pa
MTU 4470 bytes, BW 44210 Kbit, DLY 200 usec,
Serial1/1 is administratively down, line protocol is down
Hardware is M2T-T3 pa
MTU 4470 bytes, BW 44210 Kbit, DLY 200 usec,
FastEthernet4/0 is administratively down, line protocol is down
Hardware is DEC21140, address is 0050.73ff.6370 (bia 0050.73ff.6370)
MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,
(display text omitted)
78-6341-03
Slot 3—Not used
Slot 4—Modular port adapter
Slot 5—Integrated Service Module
Slot 5 Slot 3
BOOT
SM-ISM RESET ERROR
155 - MM
RX TX
RX
CEL CAR ALM
Slot 1
(display text omitted)
(display text omitted)
(display text omitted)
(display text omitted)
Slot 4
SLOT 0 SLOT 1
ACT ACT
EN
LNK LNK
0 1
FE 0 / 0 FE 0 / 1
155 - MM
RX TX
RX
EN
CEL CAR ALM
Slot 0 Slot 2
Cisco 7100 Series VPN Router Installation and Configuration Guide
Functional Overview
AC OK
DC OK
OTF
PWR
0
AC OK
SYS
RDY DC OK
CONS AUX
OTF
2
7140 - 2MM3
1-31