Cisco 7120 Series User Manual page 17

Hide thumbs Also See for 7120 Series:
Table of Contents

Advertisement

Chapter 1
Overview
The Cisco 7140-2E3 WAN ports have one enabled (EN) LED and six uplink port status LEDs (each port
has a set of status LEDs). After system initialization, the enabled LED goes on to indicate that the ports
have been enabled for operation. If the initialization fails for any reason, the enabled LED will not go
on. The LEDs are shown in
Figure 1-18 Cisco 7140-2E3 WAN Port LEDs
EN
5
I
EN
Table 1-6
LED Label
EN
RCLK
FERF
RL
AIS
OOF
LL
Cisco 7140-2AT3, Cisco 7140-2AE3, and Cisco 7140-2MM3
The Cisco 7140-2AT3 provides two high-speed, ATM ports that support full-duplex operation at T3
(45-Mbps) speeds. The Cisco 7140-2AE3 provides two high-speed, ATM ports that support full-duplex
operation at E3 (34-Mbps) speeds. The Cisco 7140-2MM3 provides two ATM ports that support
full-duplex operation at OC-3c/STM1 multimode (155-Mbps) speeds.
These models provides the following features:
78-6341-03
Figure 1-18
LEDs
RCLK FERF RL
RCLK FERF
RL
AIS OOF LL
AIS OOF LL
RCVR
XMTR
RCVR
XMTR
RCLK FERF RL
RCLK FERF RL
AIS OOF LL
AIS OOF LL
Cisco 7140-2E3 LED Descriptions
Color
State
Green
On
Green
On
Yellow
On
Yellow
On
Yellow
On
Yellow
On
Yellow
On
Up to 4096 total virtual circuits (open VCs)
Up to 1024 simultaneous SARs
ATM adaptation layer 5 (AAL5) for data traffic
Traffic shaping on a per-VC basis
IP-to-ATM CoS
Non-real time variable bit rate (nrt-VBR), unspecified bit rate (UBR), and available bit rate (ABR)
quality of service (QoS)
Operation, Administration, and Maintenance alarm indication signal (OAM AIS) cells
LAN emulation (LANE)
and described in
Table
1-6.
Function
Indicates the port is ready.
Indicates a receive clock has been detected.
Indicates the framer detected far-end receive failure.
Indicates the port is in remote loopback mode.
Indicates the framer detected an alarm indication signal.
Indicates the framer detected out of frame.
Indicates the port is in local loopback mode.
Cisco 7100 Series VPN Router Installation and Configuration Guide
Cisco 7140 Series Overview
1-17

Advertisement

Table of Contents
loading

This manual is also suitable for:

7140 series

Table of Contents