Operation Using A Computer; Setting Up The Standby Screen - Extron electronics ShareLink 200 N Setup Manual

ShareLink 200 N • Setup Guide (Continued)

Setting Up the Standby Screen

Once the ShareLink 200 N is connected and powered on, the default standby screen appears on the display:
1 1
2 2
3 3
4 4
ShareLink 200 N Standby Screen
Figure 3.
1
Instructional Screen — Provides instructions for starting a presentation. The background image of the instructional screen
can be customized (see the ShareLink 200 N User Guide for instructions on changing the background image).
2
Whiteboard icon — Click to use the display as a whiteboard. This feature allows the presenter to draw on a blank screen
using a mouse or touchscreen (see the ShareLink 200 N User Guide for instructions).
3
USB Player icon — Click to access the USB Player. This feature allows the presenter to access photos, videos, audio files,
and documents directly from the connected USB flash drive (see the ShareLink 200 N User Guide for instructions).
4
IP Address — Use this IP address to identify and access the ShareLink 200 N during connection.
5
Code — Use this code to access the ShareLink 200 N through the software (see
to the ShareLink 200 N
for instructions).
6
Receiver — Use this hostname to identify and access the ShareLink 200 N during connection.

Operation Using a Computer

Connecting a Computer to the ShareLink 200 N
A computer can be connected to the ShareLink 200 N wirelessly through an external wireless access point (WAP), or wired
through a network device. See the instructions below for your preferred connection method.
Connecting through an External WAP
Ensure that the external WAP and the ShareLink 200 N are wired to the same network.
1.
Ensure that the ShareLink 200 N is powered on and that wireless network capability is enabled on your computer.
2.
Open the wireless networks on your PC and connect to the external WAP.
3.
Connecting through a Network Hub, Switch, or Router
Ensure that your computer is connected to the network through a hub, switch, or router.
1.
Connect the RJ-45 connector of the ShareLink 200 N to the network device using an RJ-45 cable.
2.
2
on the next page). This code can be customized or disabled (see the ShareLink 200 N User Guide
5 5
6 6
Running the Software and Connecting