Attach Housing To The Interface Box - Bosch VG4 Series Installation Manual

VG4 Modular Camera Series
4.7

Attach Housing to the Interface Box

The In-Ceiling Housing is attached to the Interface Box and secured by two (2) thumbscrews.
Figure 4.9 Attach Housing to Interface Box
1.
2.
3.
CAUTION!
The In-ceiling dome is provided with tether points on each side of the housing. To prevent
injury, attach a safety wire from a secure anchor point above the ceiling to a tether point on
the dome housing, see Figure 4.11, Page 82, below for an illustration of this process.
Bosch Security Systems, Inc.
Insert the In-ceiling housing through the hole in the ceiling to verify that the edge of the
hole support the unit. Then remove the housing from the hole.
Align the ball studs of the In-Ceiling Housing to the Stud Retainers on Interface Box and
attach.
Tighten the two (2) Thumbscrews to secure the Interface Box to the housing.
Figure 4.10 In-Ceiling Housing and Interface Box
1 Interface Box
2 Ball Stud
3 In-ceiling Housing
Installation Manual
4 Thumb Screw
5 Tether Point
6 Ceiling Clamp
Installing the In-Ceiling Mount | en
F.01U.162.025 | 6.0 | 2010.03
81