Installing The Pressurized Environmental Housing; Important Installation Safeguards; Vg4 Pressurized Environmental Housing - Bosch VG4 Series Installation Manual

VG4 Modular Camera Series
2.11

Installing the Pressurized Environmental Housing

The VG4 Pressurized Environmental Housing provides maximum protection for CCTV cameras
and lenses. The charge of dry nitrogen inside the housing eliminates the effects of moisture,
dust, insects, and corrosive exhaust fumes.
This section provides the details and instructions for mounting the pendant to the arm,
calibrating the pressure sensor, and pressurizing the dome with dry nitrogen.
Note: If you are installing a normal VG4 AutoDome (not a pressurized dome), skip the
remainder of this chapter.
2.11.1

Important Installation Safeguards

–
–
–
CAUTION!
Be sure to periodically examine the unit and its supporting structure. If the dome shows any
signs of wear, such as stress cracking, it should be replaced immediately.
2.11.2

VG4 Pressurized Environmental Housing

The VG4 Pressurized Environmental Housing differs from normal VG4 housings because of the
addition of a Schrader fill valve, located on the back side of the housing, and a pressure relief
valve, located on the top of the housing cap.
Figure 2.19 VG4 Pressurized Environmental Housing
1
2
Bosch Security Systems, Inc.
Installing the Pendant Arm Wall, Corner, and Mast (Pole) Mounts | en
Always use safety goggles when servicing the unit.
Never use an unregulated gas supply to pressurize the enclosure. The valve should be
regulated with a maximum of 86.18 kPa (12.5 psi) output.
PRESSURIZE USING DRY NITROGEN ONLY!
Schrader Fill Valve
Pressure Relief Valve
Installation Manual
35
F.01U.162.025 | 6.0 | 2010.03