Ethernet Connections - Bosch AUTODOME 7000 VG5-7230 Operation Manual

72 en | Connection
Caution!
Compliance with EN50130-4 Alarm Standard – CCTV for Security Applications
To meet the requirements of the EN50130-4 Alarm Standard, an ancillary uninterruptable
!
power (UPS) supply is necessary. The UPS must have a Transfer Time between 2–6 ms and a
Backup Runtime of greater than 5 seconds for the power level as specified on the product
datasheet.
Maximum Wire Distances from Power Supply to AUTODOME
24 V to AUTODOME
HD models with IVA, Outdoor
Maximum Wire Distances from Power Supply to AUTODOME 7000 HD
24 V to AUTODOME 7000
HD models with IVA, Indoor
HD models with IVA, Outdoor
11.3

Ethernet Connections

The camera connects to a 10 Base-T/100 Base-TX network either directly or via a hub. Video,
optional audio input, optional audio output, and control are transmitted over a standard
TCP/IP network using the built-in Web server. In addition, power can be supplied over the
Ethernet cable using the Bosch High PoE 60W midspan (sold separately). Power can also be
supplied over the Ethernet cable to in-ceiling models and indoor/outdoor pendant models
used in indoor applications (where the heater is not powered) using PoE+ PSEs (midspan
switches) compliant with the IEEE 802.3at, class 4 standard.
The camera can be connected simultaneously to a 24 VAC power supply and to a High PoE 60
W midspan. The camera uses power from the 24 VAC power supply. If this power supply fails,
the camera seamlessly switches power input to the High PoE 60 W midspan. The camera
switches back to the 24 VAC power supply once power is restored.
Refer to Using the IP Interface, for instructions on configuring an IP environment.
Warning!
BOSCH High PoE or PoE+ (802.3at): Use only approved High PoE or PoE+ (802.3at) devices.
For outdoor pendant applications that require heater power use only the Bosch High PoE
midspan (sold separately) to power the camera and the heaters. For in-ceiling or indoor
pendant applications that don't require heater power, standard PoE+ (802.3at) midspans or
!
switches can be used to power the camera.
When powering the camera via PoE or a midspan device, additional surge protection is
required.
If auxiliary power (24VAC camera and 24VAC heater) and High PoE are applied
simultaneously, the camera selects the auxiliary 24VAC input and draws minimal power from
the High PoE midspan.
2014.04 | 2.0 | F.01U.283.679
VA / Watts 14 AWG
(2.5 mm)
60 / 55 58 m (190 ft)
VA / Watts 14 AWG
(2.5 mm)
35 / 19 99 m (325 ft)
60 / 55 58 m (190 ft)
Operation Manual
16 AWG 18 AWG
(1.5 mm) (1.0 mm)
36 m (119 ft) 23 m (75 ft)
16 AWG 18 AWG
(1.5 mm) (1.0 mm)
62 m (205 ft) 39 m (129 ft)
36 m (119 ft) 23 m (75 ft)
AUTODOME 7000
Bosch Security Systems, Inc.