Mount Power Supply Box (Wall, Mast (Pole), And Corner Mounts) - Bosch AUTODOME 7000 VG5-7230 Operation Manual

AUTODOME 7000
6 Mount Power Supply Box (Wall, Mast (Pole), and
Corner Mounts)
Before mounting the Power Supply Box, decide if you should wire the box through the holes in
the bottom or back of the box. If wiring the box through the back, move the two (2) seal plugs
to the bottom through the holes before mounting.
Notice!
Use 3/4-inch (20-mm) NPS fittings for the holes on the bottom and back of the box. Use 1/2-
inch (15-mm) NPS fittings for the side holes.
Figure 7.1: Power Supply Wall, Mast (Pole), and Corner Mounts
1.
2.
Warning!
A stud diameter of 6.4 mm (1/4 inch) to 8 mm (5/16 inch) able to withstand a 120 kg (265 lb)
!
pull-out force is recommended. The mounting material must be able to withstand this pull out
force. For example, 19-mm (3/4-inch) minimum for plywood.
3.
4.
5.
6.
Bosch Security Systems, Inc.
Use the wall mount template supplied in the packaging box to locate the four (4)
mounting holes for the Power Supply Box.
Drill four (4) holes for the mounting anchors. If installing outdoors, apply a weatherproof
sealant around each hole at the mounting surface.
Place the Power Supply Box into the optional Trim Skirt.
Secure the Power Supply Box to the mounting surface.
For a Wall installation: Use four (4) corrosion-resistant, stainless steel studs (not
supplied). Then proceed to Step 5 below.
For a Corner installation: Secure the Corner Plate to the wall corner using four (4) studs
(not included). Then proceed to Step 5 below.
For a Mast or a pole installation: The metal straps included with the Mast mount
accommodate a pole with a diameter of 100–380 mm (4–15 in.). You must use a banding
tool (sold separately) for a mast or pole installation. Follow the instructions provided
with the banding tool to securely mount the Mast Plate to the pole. Contact your Bosch
Sales Representative to order Banding Tool P/N TC9311PM3T.
Secure the Power Supply Box to the Corner Plate or Mast Plate using the four (4) 3/8 x
1-3/4-inch bolts and split lock washers (supplied).
Attach 3/4-inch (20-mm) NPS watertight, earth-grounded conduit pipe fittings (not
supplied) to the bottom or back holes of the Power Supply Box through which you will
run the power, video, and control data wires.
Mount Power Supply Box (Wall, Mast (Pole), and Corner Mounts) | en
Operation Manual
23
2014.04 | 2.0 | F.01U.283.679