Konica Minolta bizhub C351 Service Manual page 38

Field Service Ver. 1.0 May. 2005
→
4. Click "Start" "Program"
mand Prompt.
5. Use the Command prompt to move into the uncompressed directory.
6. Specify the Drive of Compact flash, which was recognized through the procedure 3,
and execute the "mksf.bat." (Input the C: \C351\card_work>mkcf f (Drive number): in
the below figure, and push the "Enter".)
7. Once the "mkcf.bat" is executed, data writing into the Compact flash is started.
8. Upon completion of writing, CHECKSUM is executed. If CHECKSUM value is precisely
matched, "VERIFY OK" appears.
9. Remove the Compact flash from PC.
NOTE
• When removing the Compact flash, be sure to check if data is written as normal
and then remove it according to the precise removing method.
→ →
"Accessories" "Command Prompt" to open the Com-
4. Firmware upgrade
4037F2E553DA
4037F2E554DA
13