Resetting - Mercedes-Benz 2015 GLK Operator's Manual

Sliding sunroof
96
Opening and closing
Overhead control panel
Opens
:
Opens
;
Closes
=
Turn the SmartKey to position 1 or 2 in the
X
ignition lock.
Press or pull the 3 switch in the corre-
X
sponding direction.
i
If you press the 3 switch beyond the
point of resistance, an automatic opening/
closing process is started in the corre-
sponding direction. You can stop automatic
operation by pressing/pulling the switch
again.
Resetting the sliding sunroof and the
roller sunblinds
Reset the sliding sunroof and the roller sun-
blinds if the sliding sunroof or the roller sun-
blinds do not move smoothly.
Turn the SmartKey to position 1 or 2 in the
X
ignition lock.
Press the 3 switch to the point of resist-
X
ance in the direction of arrow ; and hold it
until the sliding sunroof has opened
approximately 4 in (10 cm).
Pull the 3 switch repeatedly to the point
X
of resistance in the direction of arrow =
until the sliding sunroof is fully closed.
Keep the 3 switch pulled for an addi-
X
tional second.
Press the 3 switch to the point of resist-
X
ance in the direction of arrow ; and hold it
until the roller sunblinds are open approx-
imately 4 in (10 cm).
Pull the 3 switch repeatedly to the point
X
of resistance in the direction of arrow =
until the roller sunblinds are fully closed.
Keep the 3 switch pulled for an addi-
X
tional second.
Make sure that the sliding sunroof and the
X
roller sunblinds can be fully opened and
closed again ( page 95).
Y
If this is not the case, repeat the steps
X
above again.
! If the sliding sunroof and the roller sun-
blinds cannot be fully opened or closed
after resetting, contact a qualified special-
ist workshop.
Problems with the sliding sunroof
Problem: the sunroof cannot be closed
and you cannot see the cause.
G WARNING
If you close the sliding sunroof again immedi-
ately after it has been blocked or reset, the
sliding sunroof closes with increased or max-
imum force. The reversing feature is then not
active. Parts of the body could be trapped in
the closing area in the process. This poses an
increased risk of injury or even fatal injury.
Make sure that no parts of the body are in the
closing area.
If somebody becomes trapped:
release the switch immediately, or
R
during automatic operation, push the
R
switch briefly in any direction
The closing process is stopped.
If the sliding sunroof is obstructed during
closing and reopens again slightly:
Immediately after the sliding sunroof
X
blocks, pull the 3 switch in the over-
head control panel down to the point of