Mercedes-Benz 2015 GLK Operator's Manual page 202

Driving systems
200
Make sure that the SmartKey is in position
X
2 in the ignition lock.
Make sure that the
X
gear gear setting is active in COMAND, see the
separate COMAND operating instructions.
To show the 360° camera image: engage
X
reverse gear.
The COMAND display shows the area
behind the vehicle in split screen:
vehicle with guide lines
R
top view of the vehicle
R
Selecting the split-screen and full
screen displays
To switch between split screen views:
X
switch to the line with the vehicle icons by
sliding ZV the COMAND controller.
Turn cVd the COMAND controller and
X
select one of the vehicle symbols.
To switch to full screen mode: select
X
Full Screen Full Screen
COMAND controller and press W to con-
firm.
Displays in the COMAND display
Important safety notes
! Objects not at ground level may appear to
be further away than they actually are, e.g.:
the bumper of a parked vehicle
R
the drawbar of a trailer
R
the ball coupling of a trailer tow hitch
R
the rear section of an HGV
R
a slanted post
R
Use the guidelines only for orientation.
Approach objects no further than the bot-
tom-most guideline.
Activation by R Activation by R
by turning cVd the
Top view with picture from the rear view
camera
Symbol for the split screen setting with
:
top view and rear view camera image
Yellow guide line at a distance of approx-
;
imately 13 ft (4.0 m) from the rear of the
vehicle
Yellow guide line for the vehicle width
=
including the exterior mirrors, for current
steering wheel angle (dynamic)
Yellow lane marking tires at current steer-
?
ing wheel angle (dynamic)
Yellow guide line at a distance of approx-
A
imately 3 ft (1.0 m) from the rear of the
vehicle
Vehicle center axle (marker assistance)
B
Red guide line at a distance of approx-
C
imately 12 in (0.30 m) from the rear of the
vehicle
Bumper
D
The guide lines are shown when the trans-
mission is in position R.
The distance specifications only apply to
objects that are at ground level.