Inserting The Server - Fujitsu PRIMERGY RX330 S1 Operating Manual

Hardware installation
Racks with installation depth smaller/greater than 735 mm
The lengths of the telescopic rails have to be adjusted with respect to each other
when installing in rack systems with an installation depth greater than/less than
735 mm. The length is adjusted with the spring element on the variable support
Ê Secure the telescopic rails as described in section
CENTER/DataCenter Rack" on page
Ê Mount the server (see section
the cables as described in the rack manual.
4.2.3

Inserting the server

1
Figure 6: Preparing the server
Ê Place the server rails on the three screws on both sides of the server (1) and
slide the server rails forwards to secure them (2).
The safety spring (a) must engage with an audible click.
RX330 S1
Installing/removing the server in/from the rack
39.
"Inserting the server" on page
a 2
Operating manual
"Installation in PRIME-
43) and route
43