Replacing A Processor - Fujitsu PRIMERGY RX600 S4 Options Manual

Processors
6.2

Replacing a processor

V
CAUTION!
You may only use processors of the same type on the system board.
Ê Open the server as described in the
Ê Remove the processor cover (see
Figure 10: Removing the heat sink
Ê Remove the four screws of the heat sink. First undo two diagonally opposite
screws, then the other two.
Ê Turn the heat sink carefully back and forth to loosen it. Then lift it out to
remove it.
RX600 S4
chapter "Preparation" on page
page 22)
Options Guide
Replacing a processor
17f.
27