Completion; Closing The Server - Fujitsu PRIMERGY RX600 S4 Options Manual

10

Completion

V
CAUTION!
Make sure you observe the safety notes in the
tions" on page
10.1

Closing the server

Figure 29: Mounting the housing cover
Ê Position the cover on the server in such a way that the rear edge protrudes
1-2 cm from the housing (see circle).
Ê Push the housing cover forward as far as possible.
Ê Fasten the housing cover to the front of the system with the two captive
screws (see page
Ê Install the server in the rack.
I
The relevant procedure is described in the operating manual.
Ê Fasten the server in the rack cabinet using the knurled screws.
Ê Plug in the power plugs and switch the server on.
RX600 S4
11ff.
18).
Options Guide
chapter "Safety instruc-
47