Presetting Stations Automatically; Tuning To Preset Stations; Frequency Search Function; Cd/Mp3/Wma - Alpine CDE-152 Owner's Manual

Presetting Stations Automatically

1
Press BAND repeatedly until the desired radio band is
displayed.
2
Press and hold TUNEA.ME for at least 2 seconds.
The frequency on the display continues to change while the
automatic memory is in progress. The tuner will automatically
seek and store 6 strong stations in the selected band. They will
be stored into preset buttons 1 to 6 in order of signal strength.
When the automatic memory has been completed, the tuner
goes to the station stored in preset location No.1.
Note
• If no stations are stored, the tuner will return to the original station you
were listening to before the auto memory procedure began.

Tuning to Preset Stations

1
Press BAND repeatedly until the desired band is
displayed.
2
Press any one of the station preset buttons (1 through 6)
that has your desired radio station in memory.
The display shows the band, preset number and frequency of
the station selected.

Frequency Search Function

You can search for a radio station by its frequency.
1
Press ENTER in Radio mode to activate Frequency
search mode.
The "" indicator lights up.
2
Turn the Rotary encoder to select the desired frequency.
3
Press ENTER to receive the selected frequency.
Note
• Press r in the search mode to cancel. Or, the search mode will be
canceled if no operation is performed for 10 seconds.
10
-EN

CD/MP3/WMA

SOURCE/ 
Rotary encoder


/ENTER
/ II


Playback

1
Insert a disc with the label side facing up.
The disc will be pulled into the unit automatically.
Note
• When a disc is already inserted, press SOURCE to switch to the
DISC mode.
2
While playing back MP3/WMA, press  or  to select the
desired folder.
Pressing and holding  or  will change folders continuously.
3
Press  or  to select the desired track (file).
Pressing and holding  or  will fast backward/fast
forward track continuously.
4
To pause playback, press .
Pressing  again will resume playback.
5
To eject the disc, press .
Notes
• Do not remove a CD during its eject cycle. Do not load more than one
disc at a time. A malfunction may result from doing either.
• The "" indicator lights up when a disc is inserted.
• Three-inch (8 cm) CDs cannot be used.
• Any file protected by DRM (Digital Rights Management) copy
protection, cannot be played back on this unit.
• The track display for MP3/WMA data playback is the file numbers
recorded on the disc.
• The playback time may not be correctly displayed when a VBR
(Variable Bit Rate) recorded file is played back.
• During CD/MP3/WMA playback, press r, and then you can quickly
return to the hierarchy level selected last time in the search mode.

5

4
Preset buttons
(1 through 6)