Media Drive Removal For Models 380, 390, 39H, And 397 - IBM 7012 300 Series Installation And Service Manual

Media Drive Removal for Models 380, 390, 39H, and 397

Notes:
CAUTION:
A Class 3 laser is contained in the device. Do not attempt to operate the device while
it is disassembled. Do not attempt to open the covers of the device, as it is not
serviceable and is to be replaced as a unit.
Removal
1. Remove any media from the drive.
2. Set the power switches of the attached devices to Off.
3. Set the power switch of the system unit to Off.
4. Do the "Top Cover" removal procedure on page 3-4.
5. Do the "Front Cover" removal procedure on page 3-6.
6. Disconnect the power cable and SCSI connectors from the media devices.
7. Push the latch on the left inside of the metal cover housing to release the media drive
from the housing.
8. Slide the drive assembly out the front.
9. Record the address.
10.Remove the four rail screws to detach the drive assembly from the rails. Retain the
screws.
3-22
Installation and Service Guide
1. For a translation of this notice, see System Unit Safety Information .
2. This caution only applies to the CD-ROM drive.
Rail
(Each Side)