Table of Contents
Advertisement
2/5 network setup
3/5 config download
4/5 binary download
5/5 connecting
802.1x Auth Failed
802.1x Auth Success
Ethernet Link
3.3.
By default, IP Touch sets are configured to perform auto-negotiation on both ports (LAN and PC).
Provided that the PC and the LAN switch are also configured to perform auto-negotiation, this is
the best configuration for QoS improvement.
However, depending on the network configuration, it may not always be possible to leave the
terminal in auto-negotiation: link speed and duplex of both ports can be forced to determined
values using the supervisor menu:
–
Plug in the set, as described: module IP Touch 4008 EE/4018 EE Phone - Commissioning §
Commissioning the 4008 EE or 4018 EE IP Touch Set.
–
Once the set displays initialization, press i, then # or enter the admin settings during phone
idle status.
–
Use the navigation key to select Ethernet Links
–
Modify data as requested
A configuration mismatch between the terminal and PC/LAN switch can lead to nasty effects on
the voice quality:
–
No link (or speed mismatch): 8, 9, 11 and 12
–
Packet loss (or duplex mismatch): 2, 4, 7 and 14
All Rights Reserved © Alcatel-Lucent 2009
Phase 2 is running: the set is looking for IP
addresses
Phase 3 is running: the set is trying to get a
lanpbx file
Phase 4 is running: the set is downloading a new
binary
Phase 5 is running: the set is trying to set up the
signaling link with the system
802.1x authentication has failed: RADIUS server
is unreachable, access is refused to the terminal
on the RADIUS server or the terminal has an
incorrect identity (bad login and/or password).
802.1x authentication process is complete. The
RADIUS server grants access to the terminal, the
authenticator opens its port.
Page 15
Hide quick links:
Advertisement
Table of Contents
