Table of Contents
Advertisement
Mate-Side Trunk Programming
START
CM07
Assign a trunk number to each channel on the
Mate-Side trunk.
NOTE:
CM30
Assign a trunk route number to each trunk.
Assign a trunk number, of the opposite office,
sent to the network on Event Based CCIS con-
nection. The trunk number is sent by the sub-
address to activate the relation between the
trunks used for Event Based CCIS.
NOTE 1:
NOTE 2:
CM35
Assign the trunk route data to each voice chan-
nel and common signaling channel route of the
Event Based CCIS, as Tie Lines.
NOTE:
A
DESCRIPTION
The Virtual channel number on the
Mate-Side Trunk must be an odd
number (01, 03, 05, ... 31).
CM30 Y=19 is not required when
the trunk number is sent by ISDN In-
dial dialed-in digits.
(CM35 Y=143>1)
CM30 Y=19 must be an unique com-
bination between the offices.
Follow the initial data setting in
Mate-Side trunk.
CHAPTER 3 SYSTEM DATA PROGRAMMING
•
Y=05
(1)
3201-3231: Virtual channel No. 01-31
(2)
D000-D255: Trunk No.
INITIAL
•
Y=00
(1)
000-255: Trunk No.
(2)
00-63: Trunk Route No.
•
Y=19
(1)
000-255: Trunk No.
(2)
X-XXXX: Trunk No. of the opposite office
•
Y=00
(1)
00-63: Trunk Route No.
(2)
04: Tie Line
•
Y=01
(1)
00-63: Trunk Route No.
(2)
7 : DP/DTMF (Incoming)
– 196 –
EVENT BASED CCIS PROGRAMMING
DATA
(Odd No.) of the Mate-Side
Trunk
DTMF (Outgoing)
NOTE
NWA-008852-001 Rev.5.0
98ch3002.fm
Advertisement
Table of Contents
