Table of Contents
Advertisement
• For originating calls to the ISDN network, do the following programming.
F
CM20
Assign ISDN access code to each trunk route
assigned by CM30 Y=00.
NOTE:
LCR can be used with ISDN-BRI.
Refer to Feature Programming
Manual.
CM08
Specify the timing start when making an ISDN
call from an attendant.
CM41
Specify the timing start when making an ISDN
call from a Single Line Telephone (PB/DP),
term
D
or Attendant Console, if required.
NOTE:
A # or timing start is used for outgoing ISDN calls when LCR is not invoked.
Example: 1-214-555-1212 is dialed from a D
and ship the digits only after the timing start timer has expired or # is dialed by the caller.
The # sign tells the PBX that dialing is completed.
CM8A
Assign the Type of Number of Called Party
Number.
G
DESCRIPTION
CHAPTER 3 SYSTEM DATA PROGRAMMING
•
Y=0-3 Numbering Plan Group 0-3
(1)
X-XXXX: Access code
(2)
100-163: Trunk Route 00-63
(1)
403
0 : Not available
(2)
1 : Available
•
Y=0
(1)
50
(2)
03-14: 3-14 seconds
If no data is set, the default setting is 10 seconds.
(Dialing terminated by entering #.)
Recommended setting is 05 (5 seconds).
term
. The PBX will access a bearer channel
•
Y=5000-5255
LCR Pattern No. 000-255
(1)
157: Type of Number of Called Party No.
(for E.164)
(2)
00
01
02
04
NONE : Unknown
(1)
157: Type of Number of Called Party No.
(for Private Numbering Plan)
(2)
00
01
02
03
04
06
NONE : Unknown
– 110 –
ISDN-BRI PROGRAMMING
DATA
: Unknown
: International Number
: National Number
: Subscriber Number
: Unknown
: Level 2 Regional Number
: Level 1 Regional Number
: PSTN Specific Number
: Local Number
: Abbreviated Number
NWA-008852-001 Rev.5.0
98ch3001.fm
Advertisement
Table of Contents
