Table of Contents
Advertisement
A
CM05
Assign the accommodation type of the Remote
Site to the AP number assigned by CM05 Y=0.
NOTE:
Only when accommodating the PRT
card in Remote Site, set the second
data to 1 (remote site) to the AP
number assigned by CM05 Y=0.
CM07
Assign trunk numbers to each channel number
on the DTI/PRT card.
The system allocates time slots to consecutive
channels from lowest to highest channel num-
ber assigned. To minimize the number of time
slots allocated, assign trunk numbers to the
consecutive channels on each card.
Never skip channels in CM07.
CM48
Allow second Dial Tone when dialing access
code assigned by CM20 for ISDN B channel
route.
B
DESCRIPTION
INITIAL
INITIAL
CHAPTER 3 SYSTEM DATA PROGRAMMING
•
Y=6
(1)
04-15, 20-31, 64-93: AP No.
(2)
1 : Remote Site
3 : AP card
•
Y=01
(1)
XX ZZ
XX: 04-15, 20-31, 64-93: AP No. assigned
ZZ : 00-22: B channel No. of 24DTI/
ZZ : 01-15, 17-31: B channel No. of
(2)
D000-D511: Trunk No.
Any trunk No. already assigned by CM10/
CM14 cannot be used.
•
Y=2
(1)
04
(2)
0 : For ISDN trunk route, 2nd Dial Tone
is provided.
1 : No 2nd Dial Tone
– 90 –
ISDN-PRI PROGRAMMING
DATA
by CM05
24PRT
23: D channel No. of 24DTI/
24PRT
30DTI/30PRT
16: D channel No. of
30DTI/30PRT
NWA-008852-001 Rev.5.0
NOVEMBER/15/2006
98ch3001.fm
Advertisement
Table of Contents
