P9 F07 Level - Kodak 4C8894 Installation Instructions Manual

2-8
The following default values apply only to the Scanner/Microimager 990:
Key Definition
P1 f04,2 Count only, toggle
P2 f45 Print test
P3 f09 Total document count
P4 f08 Last Image Address
P5 f37 Calibrate
P6 f30 Amount of film remaining
P7 f44 Omit printing on next document only
P8 f46 Print position
P9 f07 Level 0
P10 f98f38 Stop, End-of-Job
To enter a function code, type an f (lower case) followed by a two-digit
code (i.e., f04). Any additional information, such as a zero (0) to disable a
function, a one (1) to enable a function, or a two (2) to toggle a function, is
entered by typing a comma (,) followed by the additional information (i.e.,
f04,1 enables counting only).
Multiple function codes are entered as a string of individual function codes
with no spaces or delimiters in between (i.e., f98f38 stops the machine
and then issues an end-of-job indicator).
When using a Microimager 70 without the Advanced Function Module
installed, only two of the P-Keys are programmable: P5 and P10.
When using a Microimager 70 with the Advanced Function Module
installed, Scanner 900, Scanner 923, Scanner/Microimager 990, or
Scanner 9500, all P-Keys are programmable.
P-Keys are programmed using the following sequence of steps:
1. Select a P-Key (P1 – P10).
2. Press Return/Enter.
3. Enter the desired function.
Repeat this sequence for each P-Key you wish to (re)program.
A-61097 May 1997