Applying Detergent; Pressure Washer Rinsing; Automatic Cool Down System (Thermal Relief) - Troy-Bilt 2,700 PSI Operator's Manual

Applying Detergent

WARNING Chemical Burn Hazard.
Chemicals could cause bodily injury, property
damage or death.
• DO NOT use caustic liquid with pressure washer.
• Use ONLY pressure washer safe detergents/soaps. Follow all
manufacturers instructions.
To apply detergent, follow these steps:
1. Review use of spray tips and brushes.
2. Prepare detergent solution as required by job.
3. Pour detergent into cleaning tank.
NOTICE The cleaning tank holds one gallon.
4. Make sure black detergent spray tip is installed.
NOTICE Detergent cannot be applied with the high pressure
spray tips (White, Yellow or Red).
5. Make sure garden hose is connected to water inlet.
Check that high pressure hose is connected to spray
gun and pump. Turn on water.
NOTICE You must attach all hoses before you start the
engine.
• Starting the engine without all the hoses connected and without
the water turned ON will damage the pump.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
6. Start engine following instructions How to Start Your
Pressure Washer.
7. Rotate detergent shut-off valve on cleaning tank to "On"
position.
8. Apply detergent to a dry surface, starting at lower
portion of area to be washed and work upward, using
long, even, overlapping strokes.
9. Allow detergent to "soak in" for 3-5 minutes before
washing and rinsing. Reapply as needed to prevent
surface from drying. DO NOT allow detergent to dry on
(prevents streaking).
14

Pressure Washer Rinsing

For Rinsing:
• Operate pressure washer from a stable surface.
• Be extremely careful if you must use the pressure washer from
• Firmly grasp spray gun with both hands when using high

Automatic Cool Down System (Thermal Relief)

If you run the engine on your pressure washer for
3-5 minutes without pressing the trigger on the spray gun,
circulating water in the pump can reach temperatures above
125°F (51°C). The system engages to cool the pump by
discharging the warm water onto the ground.
"On" Position
1. Turn detergent shut-off valve to "Off" position.
2. Remove black detergent spray tip from nozzle
extension.
3. Select and install desired high pressure spray tip
following instructions How to Use Spray Tips.
4. Keep the spray gun a safe distance from the area you
plan to spray.
WARNING Kickback from spray gun can cause you to
fall.
a ladder, scaffolding, or any other similar location.
pressure spray to avoid injury when spray gun kicks back.
5. Apply a high pressure spray to a small area, then check
the surface for damage. If no damage is found, it is
okay to continue cleaning.
6. Start at the top of the area to be rinsed, working down
with same overlapping strokes as you used for washing
and applying detergent.
www.troybilt.com