Howto Use Spray Tips; Cleaning And Applying Detergent - Troy-Bilt 20344 Operator's Manual

o
=n
2. Placespray gun through hole on accessory tray on
right side of unit.
NOTE:You may also use the spray gun holder wireform
attached to the handle to store your spray gun and nozzle
extension, as shown in Featuresand Controls section.
3. insert multi-colored spray tips in spaces provided in
accessory tray.
4. Hang high pressure hose on hook attached to
accessory tray on front of tray, as shown.
Howto Use Spray Tips
The quick-connect on the nozzle extension allows you to
switch between four different quick connect spray tips. Spray
tips can be changed while pressure washer is running once
spray gun trigger lock is engaged. The spray tips vary the
_ra_attern as shown below.
LOwPressure
, _ Black
w w
', ,J Useto apply
_' detergent
m m i I
m !
I I i I
U
40° White
1750 PSi
2.3 GPM
High Pressure
i m 1
iI m
! I i !
I M I I
15° Yellow 0° Red
2200 PSi 2500 PSi
2.2 GPM 2.0 GPM
Follow these instructionsto changespray tips:
1. Pull back collar on quick-connect and pull current
spray tip off. Store spray tips in holder provided on the
accessory tray.
WARNING
The high pressure stream of water that this
equipment produces can cut through skin and
its underlying tissues, leading to serious injury
and possible amputation.
= NEVER exchange spraytips withoutthe triggerlockedon the
spraygun.
• DONOT twist spraytips whilespraying.
2. Select desired spray tip:
• For gentle rinse, select white 40° or yellow 15°
spray tip.
• To scour surface, select red 0° spray tip.
• To apply detergent, select black spray tip.
3. Pull back on collar, insert new spray tip and release
collar. Tug on spray tip to make sure it is securely in
place.
Usage Tips
• For most effective cleaning, keep spray tip from 8 to
24 inches away from cleaning surface.
• If you get spray tip too close, especially using a high
pressure spray tip, you may damagesurface being
cleaned.
• DO NOT get closer than 6 inches when cleaning tires.
Cleaning and Applying Detergent
CAUTION
Chemicals can cause bodily injury, and/or property
damage.
• NEVER usecausticliquid with pressure washer.
• UseONLYpressure washersafedetergents/soaps. Follow all
manufacturers i nstructions.
TOapply detergent, follow these steps:
1. Review use of spray tips.
2. Prepare detergent solution as required by job.
3. Pour detergent into cleaning tank.
NOTE:The cleaning tank holds one gallon.
4. Make sure black spray tip is installed.
NOTE:Detergent cannot be applied with the high pressure
spray tips (White, Yellow or Red).
5. Make sure garden hose is connected to water inlet.
Checkthat high pressure hose is connected to spray
gun and pump. Turn on water.
NOTICE
You must attach all hoses before you start the engine.
, Starting the engine withoutall the hosesconnected and without
the waterturnedONwill damage the pump.
* Damage to equipment r esulting from failureto followthis
instruction will void warranty.
6. Start engine following instructions How to Start Your
Pressure Washer.
14 www.troybiit.corn