Table of Contents
Advertisement
Three Piece
Log Set
Optional
Remote
Control
Control
Knobs
Remote Selector
Switch (Optional)
Piezo
Ignitor
Figure 1 - Log Base Assembly
REMOTE CONTROL ACCESSORIES
There are four optional remote controls that can be purchased sepa-
rately for this fireplace insert:
• wall switch
• wall thermostat
• hand-held ON/OFF remote
• hand-held thermostat remote
See Accessories, page 28.
127119-01A
PRODUCT IDENTIFICATION
Top Louver Assembly
Firebox
Hood
Firebox
Support
Screen
Assembly
OPERATION
This vent-free fireplace insert is clean burning. It requires no outside
venting. There is no heat loss out a vent or up a chimney. Heat is
generated by both realistic flames and glowing embers. When used
without the blower, the fireplace insert requires no electricity making
it ideal for emergency backup heat.
SAFETY DEVICE
This fireplace insert has a pilot with an Oxygen Depletion Sensing
(ODS) safety shutoff system. The ODS/pilot is a required feature for
vent-free room heaters. The ODS system shuts off the fireplace insert
if there is not enough fresh air.
PIEZO IGNITION SYSTEM
This fireplace insert has a piezo ignitor. This system requires no
matches, batteries or other sources to light fireplace insert.
BLOWER ASSEMBLY
This fireplace insert is equipped with a blower assembly. The blower
operates thermostatically and has a variable control. The blower
circulates heated air from the fireplace insert into the room. Use of
blower is optional.
www.Superiorfireplaces.US.com
Bottom Louver
Blower
Assembly
Assembly
Figure 2 - Fireplace Insert
PRODUCT FEATURES
Top Outer
Casing
Gas Line
Access
5
Advertisement
Table of Contents
