Troubleshooting - Shure PG Wireless Quick Start Manual

Troubleshooting

Issue
No sound or faint sound
Distortion or unwanted noise bursts
Sound level different from cabled guitar or micro-
phone, or when using different guitars
Cannot turn transmit-
ter on
8
LED Status
Transmitter Power/
Mute LED on, receiver
LEDs on
Receiver Channel
Display off
Transmitter LED glowing
or flashing red
Transmitter LED off
Transmitter LED flash-
ing red
Solution
• Perform transmitter
setup.
• Verify all sound
system connections.
• Adjust transmitter
gain.
• Make sure AC
adapter is securely
plugged into electrical
outlet and into
POWER connector
on rear panel of
receiver.
• Make sure AC
electrical outlet works
and is supplying
proper voltage.
• Replace transmitter
battery.
• Turn transmitter on.
• Make sure the +/-
indicators on battery
match transmitter
terminals.
• Insert fresh battery.
• Remove nearby
sources of RF
interference (CD
players, computers,
cell phones, digital
effects, in-ear monitor
systems, etc.)
• Select a new channel
for both receiver and
transmitter.
• Reduce transmitter
gain.
• Replace transmitter
battery.
• If using multiple
systems, change the
channel of one of the
active systems.
• Adjust transmitter
gain as necessary.
• Replace transmitter
battery.