To Attach The Embroidery Hoop To The Machine; To Attach Embroidery Foot P; Thread Holder - Kenmore 385.19005 Owner's Manual

To Attach the Embroidery Hoop to the
Machine
Turn the attaching knob (T) so it is parallel with the hoop,
and set it on the carriage
Attach the hoop by fitting the pins (_) into the carriage
holes (_;_, a nd turn the attaching knob {_ clockwise to
secure the hoop.
(D Attaching knob
(2_ Pins
(.ElCarriage holes
Caution:
• Always pi'ovide sufficient clearance for' the embroidery
carriage behind your machine before embroidery
sewing,.
. Do not try to move the carriage by hand or touch the
carriage while it is moving
- Make sure to return the carriage to the home position
before turning off the power switch (see page 57).
To Attach Embroidery Foot P
_) Embroidery foot P
[_ Loosen the thumbscrew and remove the foot holder to
the rear,.
Attach Embroidery foot P (_ to the presser- bar from
behind.
[] Tighten the thumbscrew securely with the screwdriver.
Thread Holder
To prevent the needle thread from becoming tangled, place
the thread end on the thread holder (_
Pass the needle thread through the hole on embroidery foot
P and draw it up to the thread holder..
Hang about 3/4" to 1-1/2 (2 to 4 cm) of thread from front to
back on the thread holder:.
(i_:_ T hread holder
_',_Hole on embroidery foot P
f
• /
[] %
®
J
--,.
54