Kits Contents - Parrot 3200 LS-Color User Manual

I n t R O
The Bluetooth® technology enables voice and data communications
via a short-distance radio link. It allows several electronic devices to
communicate with each other, particularly telephones and hands-
free kits.
Parrot is drawing on its long years of experience in signal pro-
cessing and voice recognition technology to introduce a hands-
free kit offering superior audio quality during calls.
Thank you for buying a Parrot hands-free kit. With the Parrot
3200 LS-COLOR, you will be able to make telephone calls from
your car while keeping your hands on the wheel.
With its colour interface and customisable wallpaper, the Parrot
3200 LS-COLOR is the most user-friendly hands-free kit. It acts as
a real extension of your mobile phone. We hope that the kit will
give you complete satisfaction.

kItS COntentS

n Colour LCD screen
n Installation cable
n Electronic control unit
n Directions for use
n Fitting accessories
n Microphone

D u C t I O n fIttInG
First of all, choose the place for the colour screen inside your
vehicle.
We would advise you to fit it in the centre of the dashboard or
near you. Make sure that you can view the screen at a good
angle and that it does not obstruct your view of the road. Once
the hands-free kit is fully installed and switched on, you can adjust
the screen's brightness.
There are two places where you can choose to fit the microphone
connection: either directly at the side of the screen or on the cable
connected to the bottom of the screen. Place the microphone to the
left of the rear-view mirror to ensure optimum audio quality.
The installation cable is equipped with ISO connectors and a line-
out jack for connecting directly to your amplifier, if applicable.
Car stereo with line-in jacks:
Preferably use this type of connection by connecting the brown
and white wires (or red and black), along with the yellow mute
wire to the back of your car stereo.
Car stereo with ISO connectors:
Disconnect the car stereo's audio and power leads. Join the
female connectors of the kit's cable to the car stereo. Join the
vehicle's audio and power supply cables to the male connectors.
If the car stereo features a mute jack, connect the yellow wire of
the kit's cable to one of the "mute-in" jacks (1, 2 or 3).
Car stereo without ISO connectors:
You must purchase an ISO adapter cable.