Kit Contents - Parrot 3200 LS-COLOR LUS User Manual

INTRODUCTION
The Bluetooth technology enables voice and data communications via a
short-distance radio link. It allows several electronic devices to
communicate with each other, particularly telephones and hands-free kits.
Parrot is drawing on its long years of experience in signal processing and
voice recognition technology to introduce a hands-free kit offering
superior audio quality during calls. The Parrot 3200 LS-COLOR PLUS
benefits from the Beamforming technology through a double microphone
built into the screen of the hands-free kit. This technology allows for
greater call quality by means of improved noise reduction.
Thank you for buying a Parrot hands-free kit. With the Parrot CK3200 LS-
COLOR PLUS, you will be able to make telephone calls from your car while
keeping your hands on the wheel. With its colour interface and customisable
wallpaper, the Parrot 3200 LS-COLOR PLUS is the most user-friendly hands-free
kit. It acts as a real extension of your mobile phone. Furthermore, you can take
the Parrot 3200 LS-COLOR PLUS screen with you when you leave your vehicle.

KIT CONTENTS

Colour LCD screen
Installation cable
Electronic control unit
Directions for use
Fitting accessories
FITTING
First of all, choose the place for the colour screen inside your vehicle.
We would advise you to fit it in the centre of the dashboard or near you.
4
Make sure that you can view the screen at a good angle and that it does not
obstruct your view of the road. Once the hands-free kit is fully installed and
switched on, you can adjust the screen's brightness.
The installation cable is fitted with ISO connectors, as well as two line-out jacks
for connecting to the car stereo's line-in jacks if applicable.
Car stereo with line-in jacks:
Use this type of connection by wiring the brown and white wires (or red and
black) to the car stereo's line-in jack and the yellow wire to the car stereo's
mute jack.
Car stereo with ISO connectors:
Disconnect the ISO connectors from your car stereo. Join the male ISO
connectors of the kit's cable to the car stereo. Join the vehicle's ISO connectors
to the female ISO connectors of the kit's cable.
If the car stereo features a mute in jack, connect the yellow wire of the kit's
cable to the corresponding "mute in" jack (Mute in 1, 2 or 3).
Car stereo without ISO connectors:
An adapter cable is required to convert the specific connections into an ISO
connector. As a result, installation will be the same as with an ISO connector.
Parrot offers a range of ISO adapter cables. Visit our website at
www.parrot.com.
Fitting the kit's cable:
Check the wiring diagram for the car stereo's ISO cable.
The red wire of the kit's cable must be connected to the constant 12V supply,
the orange wire to the ignition 12V and the black wire to ground. On some
vehicles, the red and orange wires may need to be reversed. This can easily be
done by reversing the two fuse holders. On other vehicles, the ignition 12V
may be missing from the car stereo's connectors, meaning that you must
connect the orange wire directly to an available ignition 12V source in the
vehicle. Do not connect the orange wire to the constant 12V supply,
as you could run down the vehicle's battery.
Checking the installation:
If your Parrot 3200 LS-COLOR PLUS is correctly fitted, you should see the
message "Goodbye" on the screen when you switch off your car's ignition.