Table of Contents
Advertisement
ELECTRICAL
ELECTRICAL SAFETY
■ The mains voltage must correspond to the one marked on the
technical data plate (220-230V~50Hz). Do not use other sources
of power.
■ The use of a safety circuit-breaker is recommended for the
power supply line for an intervention range of 10 to 30 rated mA.
Consult a reliable electrician.
■ Never pass the appliance over the extension cable that the
application is working, as this could cut the cable. Mark sure you
always know where the cable is.
■ Use the special cable holder for the connection of the extension
cable.
■ Never use the appliance when it is raining. Try to prevent it from
getting wet or being exposed to humidity. Do not leave it outside
overnight. Do not cut damp or wet grass.
■ The power supply cable should be checked regularly and
before using it each time, make sure the cable is not damaged
or old out. If the cable is not in good condition, do not use the
appliance; take it to an authorized service center instead.
■ Only use an extension cable that is suitable for outdoor work.
Keep it away from the cutting area, from damp, wet or oily
surfaces or with sharp edges and away from heat and fuels.
■ Use only connection or extension cord with a maximum length of
15m and a minimum cable diameter of 0.75 mm ².
If the supply cord is damaged,it must be replaced by a special cord
or assembly available from the manufacturer or its service agent.
EXTENSION CORDS
When using a cultivator at a considerable distance from the power
source, use an extension cord heavy enough to carry the current
that the tool will draw. An undersized extension cord will cause a
drop in line voltage, resulting in a loss of power and causing the
motor to overheat.
Before using an extension cord, inspect it for loose or exposed wires
and cut or worn insulation.
WARNING:
Keep the extension cord clear of the tines and working
area. Position the cord so that it will not get caught on
lumber, tools or other obstructions while you are working
with a cultivator. Failure to do so can result in serious
personal injury.
WARNING:
Check extension cords before each use. If damaged
replace immediately. Never use tool with a damaged cord
since touching the damaged area could cause electrical
shock resulting in serious injury.
English (Original Instructions)
PRODUCT SPECIFICATIONS
Rated power
Rated voltage
No load speed
Vibration
Sound pressure level
Guaranteed sound power level
Weight (without cord)
Protection degree
KNOW YOUR CULTIVATOR
See Figure 2
The safe use of this product requires an understanding of the
information on the tool and in this operator's manual as well as a
knowledge of the project you are attempting. Before use of this
product, familiarize yourself with all operating features and safety
rules.
SWITCH LOCK-OUT
The switch lock-out prevents accidental starting of the cultivator.
SWITCH TRIGGER
The switch trigger starts and stops the rotation of the tines.
See Fig.1 to Fig.13 for these parts.
1. Outer tine
2. Inner tine
3. Adjustment knob
4. Wheel/drag stake assembly
5. Plug connector
6. Switch trigger
7. Switch lock-out
8. Wheel
9. Hitch pin
10. Tine shield
11. Cord retainer rings
12. Handlebar
13. Handlebar knobs
14. Front handle
6
FEATURES
DESCRIPTION
1020 W
220-240V ~ 50Hz
340 /min
2.3m/s
, k=1.5 m/s
2
LpA:80dB(A) KpA:2dB(A)
93dB(A)
13.8 kg
IPX4
15. Button
16. Frame
17. Washer
18. Axle
19. Bracket
20. Felt washer
21. Flat edge
22. Angled edge
23. Gear box
24. Tine shaft
25. Extension cord
26. Deep position
27. Shallow position
2
Advertisement
Table of Contents
