Information Mode - ProForm STYLE 8000 User Manual

THE INFORMATION MODE
The console features an information mode that keeps
track of the total distance that the walking belt has
moved and the total number of hours that the treadmill
has been used. The information mode also allows you
to switch the console from kilometers to miles. In addi-
tion, the information mode allows you to turn on and
turn off the display demo mode.
To select the information mode, hold down the Stop
button while inserting the key into the console and then
release the Stop button. When the information mode is
selected, the following information will be shown:
An "M" for metric kilometers
or "E" for English miles will
appear in the Calories/Pulse
display. Press the speed in-
crease button to change the
unit of measurement if de-
sired.
The Distance/Incline display
will show the total number of
kilometers (or miles) that the
walking belt has moved.
The Time display will show
the total number of hours
the treadmill has been used.
Note: The console features a display demo mode, de-
signed to be used if the treadmill is displayed in a
store. While the demo mode is turned on, the console
will function normally when you plug in the power cord,
switch the circuit breaker to the reset position, and in-
sert the key into the console. However, when you re-
move the key, the displays will remain lit, although the
buttons will not function. If the demo mode is turned
on, a "d" will appear in the speed display while the in-
formation mode is selected. To turn on or turn off the
demo mode, press the speed decrease button.
To exit the information mode, remove the key from the
console.
THE OPTIONAL CHEST PULSE SENSOR
An optional chest pulse sensor offers hands-free oper-
ation as it tracks your heart rate during your workouts.
To purchase the optional chest pulse sensor, call
the telephone number on the front cover of this
manual.
If you purchase the optional chest pulse sensor,
follow the steps below to install the receiver in-
cluded with the chest pulse sensor.
1. Make sure that the power cord is unplugged.
Remove the indicated 1/2" Screws (1) and the
Access Door (93) from the Console Back (91).
2. Connect the wire on the receiver (A) to the indi-
cated wire extending from the Console Back (91).
Hold the receiver so the small cylinder is ori-
ented as shown and is facing the Console
Back. Attach the receiver to the plastic posts on
the Access Door (93) with the two included small
screws.
3. Make sure that no wires are pinched. Reattach
the Access Door (93) with the 1/2" Screws (1).
Discard the other wires included with the receiver.
91
93
1
Small
Cylinder
16
Wire
Small
Screws
A