Cleaning Instructions - Pride Mobility Jazzy 1107 Owner's Manual

V I I I .
Yearly Checks
Take your power chair to your authorized Pride Provider for yearly maintenance. This helps ensure that your power chair
is functioning properly and helps prevent future complications.
Storage
Your power chair should be stored in a dry place, free from temperature extremes. When storing, disconnect the batteries
from the power chair. See VI. “Batteries and Charging.”
WARNING! If you fail to store the unit properly, the frame can rust and the electronics can be
damaged.

Cleaning Instructions

WARNING! Never hose off your power chair or place it in direct contact with water. Your power
chair has a painted, ABS plastic body shroud that allows it to be easily wiped clean with a damp
cloth.
WARNING! Never use any chemicals to clean a vinyl seat, as they may cause the seat to become
slippery or dry out and crack. Use soapy water and dry the seat thoroughly.
Tire/Wheel Replacement
If you have pneumatic tires and you have a flat tire, you can replace the tube. If your chair is equipped with a solid tire
insert, then you must replace the whole wheel assembly. Replacement tires, tubes, and wheel assemblies are readily
available through your authorized Pride Provider.
WARNING! To avoid possible injury, be sure that the controller’s power is turned off and the
power chair is not in freewheel mode before performing this procedure.
WARNING! Completely deflate the tire before attempting repair.
Follow these easy steps for a quick and safe repair for both pneumatic and solid tires:
1. Turn off the power to the controller.
2. Set the power chair up on blocks.
3. If you are changing a pneumatic tire, completely deflate
it before removing the wheel.
4. Remove the drive wheel nut from the axle.
5. Pull the wheel off the axle.
6. Remove the screws that fasten the two rim halves
together. See figure 34.
7. Remove the old tube from the pneumatic tire and replace
it with a new tube or replace the entire assembly if it is a
solid tire.
8. Screw together the two rim halves.
9. Slide the wheel back onto the shaft. Make sure that the
key is in the axle slot.
10. Reinstall the drive wheel nut onto the axle and tighten.
11. Inflate the pneumatic tire to 35 psi (2.4 bar) (if equipped
with pneumatic tires).
12. Remove the power chair from the blocks.
Jazzy 1107
C A R E A N D
www.pridemobility.com
M A I N T E N A N C E
DRIVE WHEEL NUT
Figure 34. Jazzy 1107 Drive Wheel
47