Table of Contents
Advertisement
To register and deregister
To register a handset
Note : the registration has already been done on this device when ex-factory, antenna
icon
will appear at the top of right corner while handset power on. While antenna icon
is steady on display, it means handset has linked up with base unit.
If antenna icon
are required to re-register the handset. process as below:
1).on base unit, press
with red LED start blinking (if more 2 minutes and register not suceed , blinking will stop,
you need to re-press "PAGE" key again) .
2). press
button on handset to enter menu setting mode, then press
to find "Registration" menu,
3). press
4). if handset find base unit, display will show "PIN CODE", blinking cursor will guide to input
pin code 0000(default value).
5). if registration is sucessful, handset will give a long beep tone, then antenna icon is steady,
display will show
6 ). if registration is not sucessful, handset will return to searching status, you need to try again.
To select a base unit
The handset can be registered to different base (up to a maximum of 4) at same time,
and you can select which base you want the handset to operate with.
If you select "AUTO" the handset will link with the first of the registered
bases that it finds.
1).
In standby mode, press
2). press
3). press
button to enter handset function setting,
4). press
5). press
button to enter next step, handset will show "BASE 1,
6). press
if base number followed "
7). press
button to confirm, then handset link up to your desired base unit.
To de-register a handset
You may need to do this if you need to replace a faulty handset.
1).
In standby mode, press
2). press
~13~
blinks long time on display, it means lost linking with base units, you
button to start registering mode, base will give a beep tone
PAGE
button to start handset registering mode, handset will display "searching",
, it means it is the first handset of the base unit.
1
button to enter setting mode.
or
button to select "HS SETTINGS",
or
button to find "SELECT BASE",
or
button to scroll " BASE 2", "BASE 3", "BASE 4", "AUTO"
", it means handset had been registered on this base,
button to enter setting mode.
or
button to select "BS SETTINGS",
button
Advertisement
Table of Contents
