Table of Contents
Advertisement
To set Date and Time
Note : If you subscribe to Caller Display , your CH-D707 time and date settings will
automatically updated by the network when you receive an incoming call.
The Caller Display service only sends the month and date, not the year, so you
may still need to set the year.
If the time and date are set on the cordless handset, it will automatically be updated
on the base unit, and vice-versa, if set time on base unit, handset display time will
automatically be updated.
The format for the date is DD-MM-YYYY.
The format for clock is HH:MM.
between 12-hour(with AM/PM display) and 24-hour.
Set time on base:
In standby mode, press and hold "TIME" button till clock display flashes on "hour" setting,
then shortly press base "UP" or "DOWN key to set hour step by step, or long press "UP"
or "DOWN" button to continuously adjust the "hour".
After "hour" is set, press "TIME" button to confirm , "Minute"will flash and allow you set
"minute" on the same way as "hour" setting
* * During time setting, press "EXIT"button to exit previous setting and return to idle mode.
Set time on handset :
In standby mode, press
1).
2). press
button to select "HS SETTINGS",
3). press
button to enter the next step setting,
4). press
button to select " DATE & TIME",
5). press
button to enter the selection, it will show "SET TIME",
6).
press
button to enter time setting, blinking cursor will guides to set "hour"/"minute"
by numeral keys in sequence
7).press
button to confirm time setting and return to "SET TIME" menu.
8). press
button to select " SET DATE",
press
button to enter date setting, blinking cursor will guides to set "date"/"month"/
9).
"year" by numeral keys in sequence
10). press
button to confirm date setting.
11). press
button to go back to stand-by mode.
To set alarm tone
1. Set base Alarm
The base unit allows to set 2 clock alarm --->ALARM 1 & ALARM 2
In standby mode, press and hold
ALARM 1
till the left clock icon start blinking, and "hour" digit also start flashing , press "UP" or "DOWN"
button to adjust "hour" to your desired value, then briefly press
digit start flashing,
press "UP" or "DOWN" button to adjust "minute" to your desired value, then briefly press
key LCD display will return to previous time(which is running) and base will sound a "du"tone to
inform alarm clock 1 is set.
Note : 1). during clock setting, long press "UP" or "DOWN" key to adjust the digit continuously.
2 ). in base standby mode, shortly press
icon lights, "alarm 1" ring is switched on.
The clock format can be switched by base "TIME" button.
button to enter setting mode.
ALARM 1
key on base unit to set the time of base alarm clock 1,
ALARM 1
key to switch "alarm 1" ring on/off,
key again, "minute"
ALARM 1
while the left clock
~10~
ALARM 1
Advertisement
Table of Contents
