Table of Contents
Advertisement
4-5-1. Operating the Continuous Playback Mode
1. Entering the continuous playback mode
1 Set the disc in the unit. (Whichever recordable discs or discs for playback only are available.)
2 Press the + button and display "CPLAY MODE".
3 Press the ^ "PROGRAM" button to change the display to "CPLAY MID".
4 When access completes, the display changes to "C1 =
Note : The numbers " " displayed show you error rates and ADER.
2. Changing the parts to be played back
1 Press the ^ "PROGRAM" button during continuous playback to change the display as below.
"CPLAY MID" n "CPLAY OUT" n "CPLAY IN"
When pressed another time, the parts to be played back can be moved.
2 When access completes, the display changes to "C1 =
Note : The numbers " " displayed show you error rates and ADER.
3. Ending the continuous playback mode
1 Press the p "PROGRAM" button. The display will change to "CPLAY MODE".
2 Press the 6 (EJECT) button to remove the disc.
Note : The playback start addresses for IN, MID, and OUT are as follows.
IN
40h cluster
MID 300h cluster
OUT 700h cluster
4-5-2. Operating the Continuous Recording Mode (Use only when performing self-recording/palyback check.)
1. Entering the continuous recording mode
1 Set a recordable disc in the unit.
2 Press the + button and display "CREC MODE".
3 Press the ^ "PROGRAM" button to change the display to "CREC MID".
4 When access completes, the display changes to "CREC (
Note : The numbers " " displayed shows you the recording position addresses.
2. Changing the parts to be recorded
1 When the + "PROGRAM" button is pressed during continuous recording, the display changes as below.
"REC MID" n "REC OUT" n "REC IN"
When pressed another time, the parts to be recorded can be changed.
2 When access completes, the display changes to "CREC (
Note : The numbers " " displayed shows you the recording position addresses.
3. Ending the continuous recording mode
1 Press the p "PROGRAM" button. The display changes to "CREC MODE" and
2 Press the 6 (EJECT) button to remove the disc.
Note 1 : The recording start addresses for IN, MID, and OUT are as follows.
IN
40h cluster
MID
300h cluster
OUT
700h cluster
Note 2 : The p "PROGRAM" button can be used to stop recording anytime.
Note 3 : Do not perform continuous recording for long periods of time above 5 minutes.
Note 4 : During continuous recording, be careful not to apply vibration.
4-5-3. Non-Volatile Memory Mode (EEP MODE)
This mode reads and writes the contents of the non-volatile memory.
It is not used in servicing. If set accidentally, press the p "PROGRAM" button immediately to exit it.
18
AD =
".
AD =
".
REC
)" and
lights up.
REC
goes off.
" and
REC
lights up.
REC
goes off.
Advertisement
Table of Contents
