Table of Contents
Advertisement
4-5. SELECTING THE TEST MODE
There are 27 types of test modes as shown below. The groups can be switched by pressing the = and = buttons. After selecting the
group to be used, press the ^ "PROGRAM" button. After setting a certain group, pressing the = and = buttons switches between
these modes.
Refer to "Group" in the table for details selected.
All items used for servicing can be treated using group S. So be carefully not to enter other groups by mistake.
Display
TEMP CHECK
Temperature compensation offset check
LDPWR CHECK
Laser power check
EF MO CHECK
Traverse (MO) check
EF CD CHECK
Traverse (CD) check
FBIAS CHECK
Focus bias check
S curve CHECK
S letter check
VERIFY MODE
Non-volatile memory check
DETRK CHECK
Detrack check
TEMP ADJUST
Temperature compensation offset adjustment
LDPWR ADJUST
Laser power adjustment
EF MO ADJUST
Traverse (MO) adjustment
EF CD ADJUST
Traverse (CD) adjustment
FBIAS ADJUST
Focus bias adjustment
EEP MODE
Non-volatile memory control
MANUAL CMD
Command transmission
SVDATA READ
Status display
ERR DP MODE
Error history display, clear
SLED MOVE
Sled check
Inpossible
No function
ADJ CLEAR
Initialization of non-volatile memory of adjustment value
AG Set (MO)
Auto gain output level adjustment (MO)
AG Set (CD)
Auto gain output level adjustment (CD)
Iop Read
IOP data display
Iop Write
IOP data write
INFORMATION
Microprocessing version display
CPLAY MODE
Continuous play mode
CREC MODE
Continuous recording mode
• For details of each adjustment mode, refer to "5. Electrical Adjustments".
For details of "ERR DP MODE", refer to "Self-Diagnosis Function" on page 2.
• If a different mode has been selected by mistake, press the p "PROGRAM" button to exit that mode.
• Modes with (X) in the Mark column are not used for servicing and therefore are not described in detail. If these modes are set accidentally,
press the p "PROGRAM" button to exit the mode immediately. Be especially careful not to set the modes with (!) as they will overwrite
the non-volatile memory and reset it, and as a result, the unit will not operate normally.
Contents
Mark
Group (*)
C
S
C
S
C
S
C
S
C
S
(X)
C
(X)
C
(X)
C
A
S
A
S
A
S
A
S
A
S
(X) (!)
D
(X)
D
(X)
D
S
(X)
D
(X)
D
A
S
A
S
A
S
C
S
A
S
C
S
C
A
S
D
C
A
S
D
Group (
)
*
A: Adjust
C: Check
D: Develop
S: Service
17
Advertisement
Table of Contents
