Test Mode - Sony MDS-PC2 Service Manual

Minidisc deck
Hide thumbs Also See for MDS-PC2:
Table of Contents

Advertisement

*Note:
As this unit has only a few buttons, one button is assigned with several functions in the test mode."
Press the INPUT button to switch the functions.
Each time the INPUT button is pressed, the display switches in the following order;"
"PROGRAM" n "1" n blank n "PROGRAM"
The functions of each button change with the display.
Buttons and Corresponding Functions
Function when
Buttons
nothing displayed
1/u
1/u
6 (EJECT)
6 (EJECT)
^
^
=
= (AMS)
+
+ (AMS)
p (STOP)
p (STOP)
r (REC)
r (REC)
4-1. PRECAUTIONS FOR USE OF TEST MODE
• As loading related operations will be performed regardless of the test mode operations being performed, be sure to check that the disc is
stopped before setting and removing it.
Even if the 6 (EJECT) button is pressed while the disc is rotating during continuous playback, continuous recording, etc., the disc will not
stop rotating.
Therefore, it will be ejected while rotating.
Be sure to press the 6 (EJECT) button after pressing the p "PROGRAM" button and the rotation of disc is stopped.
4-1-1. Recording laser emission mode and operating buttons
• Continuous recording mode (CREC MODE)
• Laser power check mode (LDPWR CHECK)
• Laser power adjustment mode (LDPWR ADJUST)
• Traverse (MO) check (EF MO CHECK)
• Traverse (MO) adjustment (EF MO ADJUST)
• When pressing the r (REC) button.
4-2. SETTING THE TEST MODE
The following are two methods of entering the test mode.
Procedure 1: While pressing the INPUT button and p button, connect the power plug to an outlet, and release the INPUT button and p
button.
When the test mode is set, "[Check]" will be displayed. Rotating the INPUT button switches between the following four
groups; ···Nn Check Nn Adjust Nn Service Nn Develop Nn ···.
Procedure 2: While pressing the INPUT button, connect the power plug to the outlet and release the INPUT button.
When the test mode is set, "TEMP CHECK" will be displayed. By setting the test mode using this procedure, only the "Check"
group of procedure 1 can be executed.
4-3. EXITING THE TEST MODE
Press the p "1" button. The disc is ejected when loaded, and "Standby" display blinks, and the STANDBY state is set.
4-4. BASIC OPERATIONS OF THE TEST MODE
All operations are performed using the =
The functions of these buttons are as follows.
Function name
=
+
,
button
^ "PROGRAM"
button
p "PROGRAM"
button
16
SECTION 4

TEST MODE

Function when "PROGRAM"
is displayed
CLEAR
ENTER/YES
0 (FR)
) (FF)
EDIT/NO
PUSH (AMS)
+
, ^ "PROGRAM" button, and p "PROGRAM" button.
,
button
Function
Changes parameters and modes
Proceeds onto the next step. Finalizes input.
Returns to previous step. Stops operations.
Function when "1" is displayed
TIME
REPEAT
PLAY MODE
DISPLAY
SCROLL

Advertisement

Table of Contents
loading

Table of Contents