Universal Garage Door Opener (Homelink®) - Dodge Viper 2014 SRT User Manual

UNIVERSAL GARAGE DOOR OPENER (HomeLink®)
• HomeLink replaces up to three hand-held transmitters that operate devices such as
®
garage door openers, motorized gates, lighting or home security systems. The
HomeLink ® unit is powered by your vehicles 12 Volt battery.
• The HomeLink ® buttons that are located in the overhead console or sunvisor designate
the three different HomeLink
• The HomeLink
®
Before You Begin Programming
HomeLink®
• Ensure that your vehicle is parked out-
side of the garage before you begin pro-
gramming.
• For efficient programming and accurate
transmission of the radio-frequency sig-
nal, it is recommended that a new battery
be placed in the hand-held transmitter of
the device that is being programmed to the
HomeLink ® system.
• Erase all channels before you begin programming. To erase the channels, place the
ignition switch into the ON/RUN position, then press and hold the two outside
HomeLink ® buttons (I and III) for up to 20 seconds or until the red indicator flashes.
NOTE:
Erasing all channels should only be performed when programming HomeLink
time. Do not erase channels when programming additional buttons.
• If you have any problems, or require assistance, please call toll-free 1-800-355-3515
or, on the Internet at www.HomeLink.com for information or assistance.
® channels.
indicator is located above the center button.
E LE CT RONI CS
® for the first
91