Log Placement Instructions - Superior SDDV-35 Installation Instructions Manual

Log Installation Instructions (refer to Figure 52)
Carefully position the ceramic fi ber logs into the fi rebox as shown
here. Logs should be placed in the order shown and per the following
instructions.
1. (See photo #1) Place embers on the front and sides of the burner.
Do NOT place embers over any of the slots on the burner. Place the
volcanic stone in front of the burner per instructions in Figures 52
(also see Placement of Glowing Embers & Install Decorative Volcanic
Stone on Page 28).
MODEL SDDV-35 & SDDV-40

Log Placement Instructions

LOG SET
SSDV-35 Cat. # H5044, SSDV-40 Cat. # H5045
* Item Description
A Log, Rear
B Log, Right
C Log, Left
* Item "letters" above correspond to photos
Firebox Accessories / Parts
Cat. No. Model No.
Bag of Glowing Embers
88L53 FGE
(1 oz. rockwool)
Bag of Decorative
80L42 FDVS
Volcanic stone
Place Embers & Volcanic stone as Shown.
1
Do NOT place embers over slots on burner.
Front left log
locating bracket
Volcanic
stone
The 2 notches on the bottom of log (A) rest on the
2
locating brackets. Push rear log against back wall.
Figure 52
Description
Install the Embers, Volcanic
stone and Logs in the order
shown here (1 through 4) and
per the instructions on this page.
Rear log locating
brackets
Embers
Front right log
Locating Pins
locating bracket
A
Locating Brackets
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
2. (See photo #2) Place the rear log (A) as shown. Position the 2
notches on the bottom of the log over the 2 corresponding locating
brackets.
3. (See photo #3) Place the right front log (B) as shown. The right
locating pin on burner fi ts into corresponding hole on the bottom of
log. Position the notch on the bottom of the log over the right front
locating bracket (the bracket is shown in photo #1).
4. (See photo #4) Place the left front log (C) as shown. The left locat-
ing pin on burner fi ts into corresponding hole on the bottom of log.
Position the notch on the bottom of the log over the left front locating
bracket (the bracket is shown in photo #1).
A
SDDV-35 Log Set Shown.
The 35 & 40 log sets are
the same except for
width of rear log.
C
Bag of Glowing
Embers (rockwool)
3
Place right
front log (B)
as shown
4
C
locating
bracket
A
Pin on burner fi ts into hole on log bottom
A
Pin on burner fi ts into hole on log bottom
B
Separate into
Quarter Size
(separate) Pieces
B
locating
bracket
B
29