Configuring Snmp - ZyXEL Communications XGS-4728F User Manual

Chapter 40 Access Control

40.3.4 Configuring SNMP

From the Access Control screen, display the SNMP screen. You can click Access
Control to go back to the Access Control screen.
Figure 205 Management > Access Control > SNMP
The following table describes the labels in this screen.
Table 129 Management > Access Control > SNMP
LABEL
General Setting
Version
Get Community
Set Community
344
DESCRIPTION
Use this section to specify the SNMP version and community (password)
values.
Select the SNMP version for the Switch. The SNMP version on the Switch
must match the version on the SNMP manager. Choose SNMP version 2c
(v2c), SNMP version 3 (v3) or both (v3v2c).
Note: SNMP version 2c is backwards compatible with SNMP
version 1.
Enter the Get Community string, which is the password for the
incoming Get- and GetNext- requests from the management station.
The Get Community string is only used by SNMP managers using
SNMP version 2c or lower.
Enter the Set Community, which is the password for incoming Set-
requests from the management station.
The Set Community string is only used by SNMP managers using
SNMP version 2c or lower.
XGS-4728F User's Guide