8
Mounting the sewing lamp
.01.09
Screw the sewing lamp onto the table top (wood screws 5x35) and have the lamp
connected by an appropriately trained person.
01.10
8.
Mounting the spool holder
Mount the spool holder
Insert the spool holder into the hole in the table top and and fasten it with the
enclosed nuts.
8.
Initial operation
02
Before operating the machine for the first time, check the electrical leads and the
pneumatic connecting hoses for any damage.
Clean the machine thoroughly and lubricate it (see chapter 10 Care and maintenance).
Connect the machine to the power supply.
Connect the machine to the compressed air supply. The manometer must display a
pressure of approx. 6 bar. If necessary adjust the air pressure to this value.
8.
Switching the machine on / off
03
Switch the machine on (see chapter 7.01).
Carry out a test run.
= The sewing lamp is not included as a standard accessory in the scope of the normal
delivery.
Mounting and initial operation
8 - 5