Configuring 2-Rate 3 Color Marker Settings - ZyXEL Communications XGS-4728F User Manual

The following table describes the labels in this screen.
Table 107 IP Application > DiffServ
LABEL
Active
Port
*
Active
Apply
Cancel

35.3.1 Configuring 2-Rate 3 Color Marker Settings

Use this screen to configure TRTCM settings. Click the 2-rate 3 Color Marker link
in the DiffServ screen to display the screen as shown next.
XGS-4728F User's Guide
DESCRIPTION
Select this option to enable DiffServ on the Switch.
This field displays the index number of a port on the Switch.
Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports.
Use this row first to set the common settings and then make adjustments
on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you
make them.
Select Active to enable DiffServ on the port.
Click Apply to save your changes to the Switch's run-time memory. The
Switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Chapter 35 Differentiated Services
299