Enabling Automatic Camera Tracking (Powercam Plus Only) - Polycom VSX Series Getting Started Manual

Enabling Automatic Camera Tracking (PowerCam Plus Only)

© Polycom, Inc.
To show, move, or turn off the PIP during a call:
Press PIP on the remote control to display the PIP on screen.
While the PIP has a yellow border, press
different corners of the screen.
After a brief pause, the PIP border turns blue. Then, press
turn the PIP off.
To swap the views shown in the PIP and the main screen:
1. If the PIP is not showing, press
display the PIP on screen.
2. Press Camera and select the
During calls using a single monitor and the Dual Monitor Emulation feature
(split-screen viewing), without content, you can use the PIP button to scroll
through the following screen layouts:
1. Near and far sites, same size, side by side
2. Far site big, near site small
3. Near site big, far site small
4. Near site, full screen
5. Far site, full screen
If you are using a VSX 7000e or VSX 8000 with the Polycom PowerCam™ Plus
camera, you can set the camera to automatically point to the person speaking
or to move to the preset location that is closest to the speaker. When you
enable this voice tracking, you can view the people who are speaking
throughout the meeting without having to manually adjust the camera. Use
this feature if you expect the meeting participants to sit or remain somewhat
stationary during the meeting.
Automatic camera tracking is temporarily disabled when your site is muted, when the
people at the far site are speaking, and when Polycom StereoSurround™ is enabled.
To enable automatic camera tracking to the speaker:
1. Press Near or
2. Press Auto until you see "Automatic Camera Tracking."
PIP on the remote control to
Swap PIP icon.
Far to choose the near-site or far-site camera.
C W
ONTROLLING HAT
PIP repeatedly to move it to
PIP to
Y S
OU EE
13