Standards, Certificates And Approvals - Siemens Simatic MP 377 Operating Instructions Manual

Safety instructions and approvals

2.3 Standards, certificates and approvals

Intended purpose
Commissioning of the HMI device is forbidden until it has been absolutely ensured that the
machine in which the HMI device is to be installed complies with Directive 98/37/EC or
Directive 2006/42/EG as of 29 December 2009.
2.3 Standards, certificates and approvals
Note
The following overview shows possible approvals. The HMI device itself is certified as shown
on the label on its rear panel.
Ex approval
For the HMI device
● EN 60079-0
● EN 60079-15
● EN 61241-0
● EN 61241-1
the following approvals are in place:
The design examination certificate is available at the following Internet address:
"http://support.automation.siemens.com"
CE approval
The HMI device meets the general and safety-related requirements of the following EC
directives and conforms to the harmonized European standards (EN) for programmable logic
controllers published in the official gazettes of the European Union:
● 2004/108/EC "Electromagnetic Compatibility Directive" (EMC Directive)
● 2006/95/EC "Electrical Equipment Designed for Use within Certain Voltage Limits" (Low-
● 94/9/EU "Devices and protection systems for use in potentially explosive areas"
16
WARNING
II 3 G
II 3 D
Voltage Directive)
(Guidelines for Explosion Protection)
Ex nA II Tx
Ex tD A22 IP6X T xx °C
x ... Temperature values, see design examination certificate
MP 377 15" Touch daylight readable (WinCC flexible)
Operating Instructions (Compact), 04/2009, A5E02532357-01