Motorola WiNG 5.5 Reference Manual page 344

5 - 258 WiNG 5.5 Access Point System Reference Guide
VRRP Mode Check
7. Set the following OSPF Overload Protection settings:
Number of Routes
Retry Count
Retry Time Out
Reset Time
8. Set the following Default Information:
Originate
Always
Metric Type
Route Metric
9. Refer to the Route Redistribution
10. Select the + Add Row
include connected, kernel and static.
11. Select the Metric Type
Metric option to define route metric used with the redistributed route.
12. Use the OSPF Network
13. Select the + Add Row
Additionally, define the OSPF area (IP address) to which the network belongs.
14. Set an OSPF Default Route Priority (1 - 8,000) as the priority of the default route learnt from OSPF.
15. Click the Clear
16. Select the Area Settings
An OSPF Area contains a set of routers exchanging Link State Advertisements (LSAs) with others in the same area. Areas
limit LSAs and encourage aggregate routes.
Select this option to enable checking VRRP state. If the interface's VRRP state is not
Backup, then the interface is published via OSPF.
Use the spinner controller to set the maximum number of OSPN routes permitted. The
available range is from 1 - 4,294,967,295.
Set the maximum number of retries (OSPF resets) permitted before the OSPS process is
shut down. The available range is from 1 - 32. The default setting is 5.
Set the duration (in seconds) the OSPF process remains off before initiating its next
retry. The available range is from 1 - 3,600 seconds. The default is 60 seconds.
Set the reset time (in seconds) that, when exceeded, changes the retry count is zero.
The available range is from 1 - 86,400. The default is 360 seconds.
Select this option to make the default route a distributed route. This setting is disabled
by default.
Enabling this setting continuously maintains a default route, even when no routes
appear in the routing table. This setting is disabled by default.
Select this option to define the exterior metric type (1 or 2) used with the default route.
Select this option to define route metric used with the default route. OSPF uses path
cost as its routing metric. It's defined by the speed (bandwidth) of the interface
supporting given route.
table to set the types of routes that can be used by OSPF.
button to populate the table. Set the
option to define the exterior metric type (1 or 2) used with the route redistribution. Select the
table to define networks (IP addresses) to connect using dynamic routes.
button to populate the table. Add the IP address and mask of the network(s) participating in OSPF.
button next to the Clear OSPF Process
tab.
Route Type used to define the redistributed route. Options
field to clear all OSPF routing entries.